Hi,
I've just found out that I need to flush my central heating system, it was recently comissioned and acid flux was used on some of the copper pipework..
It currently has sentinel x100 inhibitor in it.. I plan to put sentinel X300 cleanser in to remove traces of flux etc.. then refil with X100 after fully clearing the X300 (what fun) - already have the sentinel stuff so hopefully you won't all tell me it's rubbish
My question is do I need to remove all traces of x100 before I put in x300 or can I just drain down enough of the current to pull in the x300 and have them both in together? I'd rather do this as there is underfloor heating involved and it's not so easy to drain down..
cheers
Trevor
I've just found out that I need to flush my central heating system, it was recently comissioned and acid flux was used on some of the copper pipework..
It currently has sentinel x100 inhibitor in it.. I plan to put sentinel X300 cleanser in to remove traces of flux etc.. then refil with X100 after fully clearing the X300 (what fun) - already have the sentinel stuff so hopefully you won't all tell me it's rubbish
My question is do I need to remove all traces of x100 before I put in x300 or can I just drain down enough of the current to pull in the x300 and have them both in together? I'd rather do this as there is underfloor heating involved and it's not so easy to drain down..
cheers
Trevor