• Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.

Condensate trap for bathroom extractor fan

Joined
16 Dec 2007
Messages
9
Reaction score
0
Country
United Kingdom
Had a new bathroom a few months ago and had poor performance from shower extractor.
Took a look in loft and it is a bad install ductwork is badly done into vertical extraction and no codensate trap. Moved the ductwork can hear water in there. What do i need to do/buy to rectify?
 

Attachments

  • 20251117_153849.jpg
    20251117_153849.jpg
    226.5 KB · Views: 33
  • 20251117_153839.jpg
    20251117_153839.jpg
    265.8 KB · Views: 36
Not the worst I’ve ever seen, but I’d re-do it properly.

Ideally use rigid ducting, with a constant upward gradient. Then any condensation would run back to the shower. If you fitted a condensate trap, where would you drain it to?

It should probably be insulated.

(Is that a boiler terminal in the roof that it’s connected to?It seems to have a taped-off second connection.)
 
Hose looks far too long , shorter the better .Insulated hose reduces condensation .
 
Last edited:
Vertical vents are NEVER a good idea, especially that long
 
Last edited:
Further down i have another fan which terminates under eaves is it possible to connect two fans to one exit run?
 
plan b will attempt to install new duct exiting through soffit. no way to reach soffit comfortably safely so will try reverse install will this work?
1- 102mm hole from loft side into soffit
2-attach ducting onto vent securely
3- from upstairs window feed otherside of ducting into soffit hole
4-back into loft and pull through attach to fan.
only problem is the screws for vent plate.
In theory seems possible please correct me if im wrong.

There is alot of water in the current setup and am concerned about this potentially being a hazard
 
We insisted that our fitter drilled a hole through the brick wall and fitted the conduit through that.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top