Hi, when core drilling a hole for the toilet waste that exits at a right angle to the toilet so will be connected via a bent pan connector. What height should this be drilled? If a standard toilet outlet is 7.5 inch?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Core drilling hole for toilet waste
- Thread starter Fallout
- Start date
N
Newboy
It depends on how far from the pan you are - allow for a fall of not greater than 1:50 from the pan spigot.
N
Newboy
Centre the core between 5mm and 10 mm lower than the centre of the pan spigot and (assuming you're drilling from the inside) drill at a slight downward angle
N
Newboy
Given that sanitary fittings seem to be coming from all over the place, I'd be inclined to select the pan first. As a general guide 180 mm to the centre line of the spigot but check before you core!
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
