Curved path edging

[InvictusBob]

I want to construct a curved gravel path, radius about 5m. If I could bend it ok I would use the 200 x 25mm timber I've used for the straight paths but I think it would be a struggle. I would welcome advice on this.

 

[holmslaw]

Make an edging using paving blocks or engineering bricks.

 

[InvictusBob]

Thanks Holmslaw, but that's a little too demanding in terms of both cost and skill level.

 

[WabbitPoo]

You could make a series of part cuts across the timber, to say half to three quarters of the depth, so making it bendy.

 

[InvictusBob]

Thanks WabbitPoo, but that's an awful lot of cuts with over 60m of board! We look like going for a cheat and making a dodecagon instead of a circle.