Hi All
Looking to Fit a Door Standard UPVC in the side of our garage so we do not have to open the main up and over one each time, but I have got to cut the brick and Block work out for the door to go there, I take it I will need an angle grinder type tool with a 12" diameter Diamond disc to do this, also I will have to cut a concrete lintel to fit above the door.
Any advise on tool needed and method of doing this would be a super help.
Kind Regards
Looking to Fit a Door Standard UPVC in the side of our garage so we do not have to open the main up and over one each time, but I have got to cut the brick and Block work out for the door to go there, I take it I will need an angle grinder type tool with a 12" diameter Diamond disc to do this, also I will have to cut a concrete lintel to fit above the door.
Any advise on tool needed and method of doing this would be a super help.
Kind Regards