Danfoss TP7000-RF + RX-1 Thermostat Wiring

[Happyunited]

Hi

I have just purchased one of these and I just want to confirm a bit of the wiring before I switch it on.

This is the manual for it and page 6 tells you about the wiring, mine is the RX-1 receiver. http://www.heatingcontrolsonline.co.uk/instructions/TP7000_-_UK_only.pdf

Here is a picture of the old one which I am replacing and its wiring, I need to put the existing 4 wires into my new receiver. The L & N is pretty obvious but the switch wires are the ones I am not so sure about. Going by what page 6 on the link above what hole numbers should I put my switch wires in? 1, 2, 3 or 4????

http://i35.tinypic.com/sy0e15.jpg (Existing Timer wiring)

Your help is greatly appreciated.

 

[D_Hailsham]

Old stat terminal 3 = New stat terminal 2

Old stat terminal 5 = New stat terminal 3

 

[Happyunited]

Old stat terminal 3 = New stat terminal 2

Old stat terminal 5 = New stat terminal 3

Thank you very much. i'll give that a whirl.