Having problem with my smoke detectors connected to my Accenta G4 panel.
The zone has been set as fire and all flags set as helpfully advised in an earlier post on here but when I push test button on detectors the 2 led lights up but no bells etc so I must have a wiring error.
The terminals on the detector are:
A & B: Alarm relay normally closed. I have connected these to Zone 8 in the panel.
C: No connection (use for loopthrough if required)
D & E: 0v & 12v. I have connected these to the 0v & 13v at the top of the panel.
I did notice that next to these top 13v & 0v terminals is a terminal marked *fire*.
Dunno if I should have wired something in there???
Really thankfull to have found this site for sure.
The zone has been set as fire and all flags set as helpfully advised in an earlier post on here but when I push test button on detectors the 2 led lights up but no bells etc so I must have a wiring error.
The terminals on the detector are:
A & B: Alarm relay normally closed. I have connected these to Zone 8 in the panel.
C: No connection (use for loopthrough if required)
D & E: 0v & 12v. I have connected these to the 0v & 13v at the top of the panel.
I did notice that next to these top 13v & 0v terminals is a terminal marked *fire*.
Dunno if I should have wired something in there???
Really thankfull to have found this site for sure.