Dot and Dab window reveals

[scoobydo123]

Hi,

Just stripped the bathroom back to brick and have dot and dabbed all the walls apart form the wall where the window is. What method should be adopted on the reveals? Front face first with 20mm over the highest point and then infill the reveals or reveals first then go extra on the dabs and press the front face in.

Edit should have put that I am going to fully tile

Cheers

 

[PrenticeBoyofDerry]

Do your reveals first, assuring they are level plumb/true.
Then when you fit the wall boards they can sit over the top of the reveal boards and be cut/trimmed as required.

 

[scoobydo123]

Slightly confused on this! Would there not be a gap or do you make the reveals deeper than is actually required thus sticking out further than the actual wall. I can then invisage having to measure the wall board to but against the reveal board and then trim the extra from the reveal board once all set.