I need to cross over an existing foul water pipe with a surface water pipe as per the pic. I think if I expose the pipes further back the surface water pipe may eventually clear the top of the foul pipe.
Was thinking of using 2 30 degree bends to create an off-set.
Will this still be rodable or should I go for 2 15 degree bends?
Any other ideas?
Need to connect these 2 open ends together with a T and continue the run for a rodding point
Original pipe angles.
Was thinking of using 2 30 degree bends to create an off-set.
Will this still be rodable or should I go for 2 15 degree bends?
Any other ideas?
Need to connect these 2 open ends together with a T and continue the run for a rodding point
Original pipe angles.