I have to pass a 40mm pipe through a 6" by 4" floor joist (not a regular joist, but at 90 degrees to the main floor joists, I think it is supporting the hearth or chimney in an adjoining room). The hole would be very near one end of the joist and roughly centred top-to-bottom. Do I need to strengthen the drilled joist to compensate, perhaps fixing a noggin alongside?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Drilling joist for waste pipe
- Thread starter jon92
- Start date
Technically all drilled holes on a joist should be made in the middle or neutral axis, notches etc on top away from the edges. The hole drilled should be no more than .25 diameter of the depth of the joist so your joist is around 144-46mm in depth a quarter of that is maximum diameter of your hole - 36-37mm so close - up to you, depends what it is supporting and whether as Big all has asked if the span is very short.
Thanks for the replies, I'll have to bite the bullet I think. Given the short span it should be ok, I'll add some extra support too. Keep an eye out for me in the DIY Disasters forum.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
