END PANELS COOKE AND LEWIS

[TOMMY THE CAT]

Ok help you guys can help (you usually do!)
Ive got a b&q designed kitchen im fitting and are not sure about the end panels.Its the solid oak kitchen I have a free standing dishwasher with clad on door which is next to the sink i have two clad on panels to go either side of it .
Do the oversize end panels go down to the floor or cut off level with the bottom of the carcass? I presume the end panels come to the front of the door ie flush to the front of the door/ drawers?
I also have a built in oven going into a cabinet so same question with that too!
Im slowly going mad.....well the missus is at me.

Dave

 

[misterhelpful]

The end panels do generally run down to the floor as seen here: END PANEL STICKY-OUTY BIT but if you prefer the look of one straight run of plinth, you can trim the lower section out to accept it.