Hi Guys ,
just a question about an icon 30 12volt bathroom fan .Mine shook itself to bits and stopped working .The impellar snapped off its mountings .I have the same as a replacement under warranty .I have changed them over but the new one doesnt kick in .It has a humidity module which switches fan on when moisture is detected in th air .
I have power to the module but it only reads as 4 volts .
My question is ,does this mean the transformer is goosed as well .I did get a new one with the fan but was not going to fit it if the old one is ok as it is buried in the floor upstairs above the downstairs bathroom so means lifting carpet .floor boards etc .
So should the power be reading 12 volts at the module in th fan where the power cable is connected .(I am thinking it should )but i need it confirming before I start a major job of lifting floors etc .
Many Thanks for your help .
Regards
Rob.
P.s the fan was making a right racket before giving up altogether ,would this have put strain on the transformer ??
Tried to give as much info as possible so apols for the long winded short question !!
just a question about an icon 30 12volt bathroom fan .Mine shook itself to bits and stopped working .The impellar snapped off its mountings .I have the same as a replacement under warranty .I have changed them over but the new one doesnt kick in .It has a humidity module which switches fan on when moisture is detected in th air .
I have power to the module but it only reads as 4 volts .
My question is ,does this mean the transformer is goosed as well .I did get a new one with the fan but was not going to fit it if the old one is ok as it is buried in the floor upstairs above the downstairs bathroom so means lifting carpet .floor boards etc .
So should the power be reading 12 volts at the module in th fan where the power cable is connected .(I am thinking it should )but i need it confirming before I start a major job of lifting floors etc .
Many Thanks for your help .
Regards
Rob.
P.s the fan was making a right racket before giving up altogether ,would this have put strain on the transformer ??
Tried to give as much info as possible so apols for the long winded short question !!