Hello
My problem is
Lack of communication between thermostat and controller receiver
The products
Ferroli optimax he plus 31 C (boiler)
radio Wireless thermostat ferrolli 30800009
Installation is a doddle, one multi plug that plugs into pcb terminal block
Then remove loop wire, and connect the two remaining grey wires.
Following the instruction to the letter see instructions on link below
http://bit.ly/Yuc5t4
Page 8 appears to relate to my boiler
page 9 relates to the radio link installation
When i get to step 4 "Stop continuous radio operation" , this where it all goes wrong, i lose communication and the red light remains stubbornly lit on the receiver.
There is no trouble shooting guide so i am at a loss as what to try next.
My problem is
Lack of communication between thermostat and controller receiver
The products
Ferroli optimax he plus 31 C (boiler)
radio Wireless thermostat ferrolli 30800009
Installation is a doddle, one multi plug that plugs into pcb terminal block
Then remove loop wire, and connect the two remaining grey wires.
Following the instruction to the letter see instructions on link below
http://bit.ly/Yuc5t4
Page 8 appears to relate to my boiler
page 9 relates to the radio link installation
When i get to step 4 "Stop continuous radio operation" , this where it all goes wrong, i lose communication and the red light remains stubbornly lit on the receiver.
There is no trouble shooting guide so i am at a loss as what to try next.
