fitting a floor joist support beam.

G

george765

The structural engineer has specified 3x 50mmx200mm timbers bolted together at 500mm centres for my floor span. I understand and have seen timber to masonary joist hangers, but do they make a hanger for a tripple beam ? or do you use three seperate hanger (but surely they would conflict with each other ?)
advice much apreciated.
george
 
Sponsored Links
Most likely you'll have to cut into the wall to accept the beam. It may involve fitting padstones and wrap and secure the ends which sit in the wall with Damp Proof Membrane fixed with galvanised clout nails too.
 
thanks, been back to s/e since posting and your spot on !
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top