- Joined
- 16 Jan 2016
- Messages
- 174
- Reaction score
- 6
- Country
Ok. So. Im trying to fit a fancy new tap. To fit it will be easy. I think. Its just that the flexipipe that is there from the copper is in a REALLY hard place to get a spanner on. Litrelly. hard!!
So i was thinking, cant i just connect new ones to the one with the tap? But it would be female to female.
Is there a thing such as a little connector. A couple inches long that will connect female to female. (A double ended male join?)
I cant just use the existing flexi to the tap. As thats female to female end to end. Whereas the tap, has a big end and a small end (small end going to the tap)
So i was thinking, cant i just connect new ones to the one with the tap? But it would be female to female.
Is there a thing such as a little connector. A couple inches long that will connect female to female. (A double ended male join?)
I cant just use the existing flexi to the tap. As thats female to female end to end. Whereas the tap, has a big end and a small end (small end going to the tap)