Hi
Newbie to this forum so bear with me pls
I'm installing a Galaxy Flex V3 and wanted to check my thinking..
I installed a Galaxy 2-20 about 9months ago, but was told that the 2-20 is now no longer available and the Flex V3 was the replacement. However, the menus although similar have some differences.
Bellbox connection to Texecom Odyssey 3E
Can you confirm
FLEX >> Odysssey
+12v from any zone >> A [12v]
OP1 Bell >> B [ bell]
OP2 strobe >> S [strb]
T >> C [tamp rtn]
0volt >> D [0v]
Also, the User Notification in the Comms section; is this direct input of the required mobile numbers, not via a TAP provider as the 2-20 was?
How do you stop the FLEX from trying to contact a ARC and just do mobile SMS only?
thanks in advance
Newbie to this forum so bear with me pls
I'm installing a Galaxy Flex V3 and wanted to check my thinking..
I installed a Galaxy 2-20 about 9months ago, but was told that the 2-20 is now no longer available and the Flex V3 was the replacement. However, the menus although similar have some differences.
Bellbox connection to Texecom Odyssey 3E
Can you confirm
FLEX >> Odysssey
+12v from any zone >> A [12v]
OP1 Bell >> B [ bell]
OP2 strobe >> S [strb]
T >> C [tamp rtn]
0volt >> D [0v]
Also, the User Notification in the Comms section; is this direct input of the required mobile numbers, not via a TAP provider as the 2-20 was?
How do you stop the FLEX from trying to contact a ARC and just do mobile SMS only?
thanks in advance