Can somebody advise if the below is the correct way to wire up two AG8 bell boxes to the Galaxy G2-20.
Currently have bell box jumpers set on test but bell fuse blows after a few minutes.
When jumpers set to battery, unable to disable bell case tamper to carry out work on the boxes/system without them going off, is there a setting in engineer mode.
Thanks for any advice.
Currently have bell box jumpers set on test but bell fuse blows after a few minutes.
When jumpers set to battery, unable to disable bell case tamper to carry out work on the boxes/system without them going off, is there a setting in engineer mode.
Thanks for any advice.