Glow-Worm PCB.



Hi Chaps,
The monica is Tippo, and I'm new to the Forum, and I would
like some help please. I am having trouble with my PCB on my
Glow-Worm Hideaway 60 c FF, G.C. No,41-047-40, year 2002.
I think the problem is either the 100K rheostat boiler tempereture
control, or Relay RL 2.
Does anyone have any idea where I might purchase a new or
secondhand PCB board.
I have made enquiries to Piher the makers of the switch and I'm
awaiting a reply.
I would be much obliged if someone can help Thanks.

"All The Best To Everyone"


Tippo. :evil:
Sponsored Links
Hi Gasman 17,
Thanks for the reply, Yes fan runs,
When I switch on nothing happens until I press the
RL2 to one side then boiler blows in and heats the water
to temperature set at, goes off then will not blow back
in until I press RL2 again, I've checked for dry soldier
joints but not found any, about six yrs ago I had a bit
of trouble and found it to be dry joints and it has run since
with no trouble at all.
I hope this sounds sensible.



DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Sponsored Links