Glow-Worm PCB.

[Tippo]

Hi Chaps,
The monica is Tippo, and I'm new to the Forum, and I would
like some help please. I am having trouble with my PCB on my
Glow-Worm Hideaway 60 c FF, G.C. No,41-047-40, year 2002.
I think the problem is either the 100K rheostat boiler tempereture
control, or Relay RL 2.
Does anyone have any idea where I might purchase a new or
secondhand PCB board.
I have made enquiries to Piher the makers of the switch and I'm
awaiting a reply.
I would be much obliged if someone can help Thanks.

"All The Best To Everyone"

Cheer's,

Tippo.

 

[gasman17]

whats happening to your boiler does the fan run

 

[Tippo]

Hi Gasman 17,
Thanks for the reply, Yes fan runs,
When I switch on nothing happens until I press the
RL2 to one side then boiler blows in and heats the water
to temperature set at, goes off then will not blow back
in until I press RL2 again, I've checked for dry soldier
joints but not found any, about six yrs ago I had a bit
of trouble and found it to be dry joints and it has run since
with no trouble at all.
I hope this sounds sensible.

Cheer's,

Tippo.