Heating fine, can fill a sink with hot water, if I run a bath after a couple of minutes error code 14 comes up, if I turn the tap off, after a minute the unit will operate and reheat the water in the storage unit no problem. So if it can reheat the water in the storage unit, what is stopping me running enough water to fill a bath.
Glowworm xtramax
- Thread starter telephonebill
- Start date
Sponsored Links
Could be the plate HE is blocked and boiler is going to overheat when running a bath, but the store is so small it heats before the overheat occurs.
Best to post this in the plumbing section.
Perhaps the mods will move it.
Best to post this in the plumbing section.
Perhaps the mods will move it.
D
Deleted member 105431
definately a blocked plate heat exchanger.
- Joined
- 23 Apr 2009
- Messages
- 2
- Reaction score
- 0
- Country
Can you tell me what the problem turned out to be?
I now have a similar problem with my Xtramax
thanks steve
I now have a similar problem with my Xtramax
thanks steve
Sponsored Links
Had a few plumbers come in, no answer to the problem. So I took all the water sections apart and cleaned them, put it back together and it worked OK. A spring had jammed in a component in the cold water flow route and the heat exchanger did not appear to have a blockage but a lot of stuff came out when I flushed it through with the hose. It was not as complicated as I thought it was going to be, I did keep the parts in order of how I took them out.
- Joined
- 23 Apr 2009
- Messages
- 2
- Reaction score
- 0
- Country
Mine turned out to be a blocked plate heat exchanger - works fine now! Thanks
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
