Hello, i recently just changed some taps, i had turned off the mains supply drained the system down, fitted my taps then turned the mains back on, preesure is fine throught the cold taps all round the building, but the hot is very poor, the building has a hot water tank stored at high level (immersion powered) if this makes any difference, i have waited an hour for it to fill up and pressure/flow rate through the hot water is still poor....................can someone help me asap???
Help Me!!!! Quick
- Thread starter mattyb321whufc
- Start date
probably airlocked in the top off the cylinder outlet.
you can use mains cold to backfill it to push airlock out.
you can use mains cold to backfill it to push airlock out.
Close all hot go to highest set of taps and if theres any mixer taps open both hot and cold and put something over the spout so your stopping the water and force the cold up the hot,just use a towel or if no mixers try a bit of hose and get the cold water into the hot tap its airlocked
2
2scoops0406
Are the taps suitable for gravity fed water?
So.
You need help.
And quickly, too.
What
would
happen
if
someone
wasn't
quick
enough
in
helping
you?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
