Hilmor Handibender

[PullerGas]

Does anyone know the radius of the 15&22mm formers on this bending machine??
Cheers chaps.

 

[Dan Robinson]

You're going to make me go outside in my underpants with a tape measure aren't you?

 

[PullerGas]

You're going to make me go outside in my underpants with a tape measure aren't you?

No,no!!!........I can do that, go outside in your underpants.

Is it measured from the centre to the middle of the tube?

 

[oilboffin]

I've got a ridgid one I think the radius is bigger than the hilmor.Bob

 

[PullerGas]

I've got a ridgid one I think the radius is bigger than the hilmor.Bob

Yeah, when mine is ridgid it's quite formidable too!!

 

[polesapart]

Yes, I know the radius of the concave section of the formers to a fair degree of accuracy.

But I'm only wearing a towel.

 

[oilboffin]

I expected better from you sir dick.Bob hahahahhaha

 

[PullerGas]

Further investigation wearing only Jeff's sock. The radius is centre to centre of the tube.

 

[Dan Robinson]

But wearing Jeff's sock would give you a different reading to me - I'm not wearing a sock. I don't have any big enough.

 

[dilalio]

You're all benders!

 

[dilalio]

Then again... I've been known to push, bend, and sweat!

 

[PullerGas]

You're all benders!

Here, don't knock it until you've tried it mate!!

 

[PullerGas]

But wearing Jeff's sock would give you a different reading to me - I'm not wearing a sock. I don't have any big enough.

What, no even one of them?

 

[Dan Robinson]

I suppose I could cut the end off one and double up.