Hi
I have a Honeywell g2-20 alarm system installed. I have gone to set the alarms tonight to find all the keypads are dead - ie no power. I haven't opened the main panel as I am concerned about triggering a tamper response but I can hear that this has power and there is a quiet intermittent beep.
We don't have an alarm company at the moment and it is likely to take me a couple of days to track down a good one (the local one has a bad reputation and we don't have much choice where we are located). I am worried that if it is a power issue the system might be running on battery and when this is exhausted the external alarm might go off. With no keypad access I don't know what I should do if this happens.
Any advice would be really appreciated.
Lorri
I have a Honeywell g2-20 alarm system installed. I have gone to set the alarms tonight to find all the keypads are dead - ie no power. I haven't opened the main panel as I am concerned about triggering a tamper response but I can hear that this has power and there is a quiet intermittent beep.
We don't have an alarm company at the moment and it is likely to take me a couple of days to track down a good one (the local one has a bad reputation and we don't have much choice where we are located). I am worried that if it is a power issue the system might be running on battery and when this is exhausted the external alarm might go off. With no keypad access I don't know what I should do if this happens.
Any advice would be really appreciated.
Lorri
Last edited: