I have three honeywell vipers - two are just vibration, third is with door contact.
All three will be wired to their own zones - so i dont care too much re first to alarm,
and two of the three will be hidden behind a panel, so dont really need the led either.
I'm using a galaxy dimensions 96 panel, using 2 resistors for wiring - one across, one in line. No problems with that.
The questions i have are:
1) no difference between the viper with the contact and one without for wiring. So would the panel see the door open as normally open zone? if so what does it see the vibration part - tamper?
2) am i right in using just the tamper pair, alarm pair, 12+ and 0v connections, leaving the other two off? marked as FTA and reset. or do i need the reset wired up to an output on the panel? (i think it is to reset the led not the sensor but not sure?).
All three will be wired to their own zones - so i dont care too much re first to alarm,
and two of the three will be hidden behind a panel, so dont really need the led either.
I'm using a galaxy dimensions 96 panel, using 2 resistors for wiring - one across, one in line. No problems with that.
The questions i have are:
1) no difference between the viper with the contact and one without for wiring. So would the panel see the door open as normally open zone? if so what does it see the vibration part - tamper?
2) am i right in using just the tamper pair, alarm pair, 12+ and 0v connections, leaving the other two off? marked as FTA and reset. or do i need the reset wired up to an output on the panel? (i think it is to reset the led not the sensor but not sure?).