Hi,
I have got a new heating element which I want to put into my HNC170. I have taken the back off and gained access to the heating element, however I now can't see how to actually take the heating element off to replace it. The new heating element has four cables with push fit connectors on the end. As can be seen from my photo the cable from the heating element disappears into a small hole - and I can't work out how to get access to where the cable has gone to swap over the connectors.
Anybody got a solution to this.
Thanks
//media.diynot.com/3000_2992_40701_85196240_thumb.jpg
I have got a new heating element which I want to put into my HNC170. I have taken the back off and gained access to the heating element, however I now can't see how to actually take the heating element off to replace it. The new heating element has four cables with push fit connectors on the end. As can be seen from my photo the cable from the heating element disappears into a small hole - and I can't work out how to get access to where the cable has gone to swap over the connectors.
Anybody got a solution to this.
Thanks
//media.diynot.com/3000_2992_40701_85196240_thumb.jpg