Last time it was running it stopped in the middle of the cycle and beeped 3 groups of one short, one long beep. I was able to run the drain cycle.
Now it will not start at all. It turns on, lets me select a program, but just gives me the beeps.
There are no flashing lights indicating an error code.
I've drained it, I've cleaned the filters, I've checked the water supply, I've 'reset' it by unplugging it for an hour, I've made sure the door latches fully, I've checked the base for flooding. All clear and good.
identical to the Whirlpool WFE2B19 as far as I can tell.
Neither the manual, nor hotpoints troubleshooting guide online give any mention to this error state. Hotpoint help chat donkeys say "Noone can give technical support".
I'm stumped.
Link to video of the beeping included.
Thanks.
video
Now it will not start at all. It turns on, lets me select a program, but just gives me the beeps.
There are no flashing lights indicating an error code.
I've drained it, I've cleaned the filters, I've checked the water supply, I've 'reset' it by unplugging it for an hour, I've made sure the door latches fully, I've checked the base for flooding. All clear and good.
identical to the Whirlpool WFE2B19 as far as I can tell.
Neither the manual, nor hotpoints troubleshooting guide online give any mention to this error state. Hotpoint help chat donkeys say "Noone can give technical support".
I'm stumped.
Link to video of the beeping included.
Thanks.
video