Hi,
I was planning to install thermostatic shower/bath mixer tap but it needs min. 1bar water pressure to work properly. I bought water pressure gauge to check pressure and cold is 2bar but hot is 0
Question:
Is it possible to feed HW cylinder from mains without F&E tank so i can get HW mains pressure.
I know it needs Pressure Temperature Release Valve to be installed but don't know how the conversion should be done.
CURRENT SYSTEM:
Glowworm Fuel Saver MKII (old but works fine) GroundFloor
HW Tank GroundFloor (22mm feed but I'm not sure about mains)
HW/GCH F&E Attic
Thanks in advance...
I was planning to install thermostatic shower/bath mixer tap but it needs min. 1bar water pressure to work properly. I bought water pressure gauge to check pressure and cold is 2bar but hot is 0
Question:
Is it possible to feed HW cylinder from mains without F&E tank so i can get HW mains pressure.
I know it needs Pressure Temperature Release Valve to be installed but don't know how the conversion should be done.
CURRENT SYSTEM:
Glowworm Fuel Saver MKII (old but works fine) GroundFloor
HW Tank GroundFloor (22mm feed but I'm not sure about mains)
HW/GCH F&E Attic
Thanks in advance...