icon23t spares
- Thread starter stevelan
- Start date
havn't stripped it down yet as it is only a slight weep which stops when using the heating. i didn't really want to strip it till i had the correct part in hand. there is a large nut just above pump that joins the pump to the heater matrix pipe. nut is approx 30mm across flats.
try standard pump washers with a bit of lsx from memory the original are rubber and if over-tightened crunch up the spares should be available through glow-worm if you go down that route unfortunately the manual does not show spares or part numbers.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
