Hi, My Ideal logic heat 30+, is going into L1 fault once a day. After reset, it restarts normally. The water pressure on the radiator system, is normal. The boiler would be working until going into the cooler setting overnight, but then, in the morning, I would need to go to carry out a reset, which means we wake up with house temperature too low and colder water. What would you suggest I check/do? Thank you for your help.
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Ideal Logic heat 30+ L1 fault
- Thread starter Banjara
- Start date
L1 means the boiler's flow, is getting too hot, possibly not enough water circulating through it. As an immediate fix, you could try turning the boilers own stat, down a little.
Thank you Harry - I'll tried this containment and see what is happening - I have reduced the boilers stat a bit below the eco position when it is always normally on. The question is, what is the actual potential rootcause? Why would it suddenly go into L1 when it has been working fine before? Water Pump? Fault sensor? Water flow obstructed in the pipework? Thank you
D
Deleted member 267285
Could be several things, weak pump, failing sensor, restriction(s) et al.
It was about the size of your next gas bill.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local