1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice

indesit ariston error codes

Discussion in 'Appliances' started by rocks1, 14 Jan 2009.

  1. rocks1

    Joined:
    30 Apr 2008
    Messages:
    6,138
    Thanks Received:
    1,037
    Country:
    United Kingdom
    Indesit WIDL Codes

    See also Hotpoint WF & some WD, left hand lights from top to bottom or digital display.(next page)

    widl codes - light flashing from left to right are numbers 1-4

    f01 light 4, motor triac
    f02 light 3 motor, jammed/ tacho
    f03 lights 3&4 Ntc fault
    f04 light 2. pressure sw stuck on empty
    f05 lights 2&4, pressure sw stuck on full
    f06 lights 2&3, N/A?
    f07 lights 2&3&4 heater relay
    f08 light 1. heater relay
    f09 lights 1&4 eprom/setup error
    f10 lights 1&3, pressure switch not sensing
    f11 lights 1&3&4, pump/draining error
    f12 lights 1&2, communication error
    f13 lights 1&2&4, dryer ntc/ fan motor
    f14 lights 1&2&3, dryer heater
    f15 lights 1&2&3&4, dryer heater relay
    f16 N/A
    f17 light 4, door lock
    f18 light 3 comms error (3 phase motor) power board

    f1 and f17 share the same light

    .
     
  2. PeterBill

    Joined:
    14 Jan 2009
    Messages:
    6
    Thanks Received:
    0
    Location:
    Aberdeen
    Country:
    United Kingdom
    Hi Rocks,

    I have an older machine, Indesit wi101, which does not have all the lights and no Fxx read out.

    It has a control knob which now clicks round and a single led light which flashes - this indicates the problem - mine flashes once and pauses for about 10 seconds then flashes once again ....

    Wondered if you had the error code for the flashing light?

    Pete
     
  3. rocks1

    Joined:
    30 Apr 2008
    Messages:
    6,138
    Thanks Received:
    1,037
    Country:
    United Kingdom
    its the same as the codes but no light ,refit the connections on pcb make sure they are tight if not pcb is shot
     
  4. holmwoc

    Joined:
    9 Feb 2011
    Messages:
    3
    Thanks Received:
    0
    Location:
    Plymouth
    Country:
    United Kingdom
    so i have looked at your list of error codes, and as my ariston led flashing are 1 and 4.
    going by your info ii think mine may be the eprom/set up error?

    can you advise what this means please

    regards
     
  5. rocks1

    Joined:
    30 Apr 2008
    Messages:
    6,138
    Thanks Received:
    1,037
    Country:
    United Kingdom
    Explained in your other post.
     

Share This Page