Hello
This is a general question on cable installation methods:
I have a 6mm hituf cable running through a wall from inside to outside. A want to check the current carrying capacity so looking at installation methods (BS7671) that appears to be method 1 embedded directly in masonry.... Also Clipped direct is method 1 which confuses me.
If I refer to my table (4D2A) I'm assuming I take the column headed Reference method 1 (clipped direct) although it makes no reference to embedded directly in masonry.
I'm probably being stupid so if someone could clarify I'd greatly appreciate it.
Cheers
This is a general question on cable installation methods:
I have a 6mm hituf cable running through a wall from inside to outside. A want to check the current carrying capacity so looking at installation methods (BS7671) that appears to be method 1 embedded directly in masonry.... Also Clipped direct is method 1 which confuses me.
If I refer to my table (4D2A) I'm assuming I take the column headed Reference method 1 (clipped direct) although it makes no reference to embedded directly in masonry.
I'm probably being stupid so if someone could clarify I'd greatly appreciate it.
Cheers