I'm trying to fit a Salus RT500RF to my existing Ikon23T boiler which doesn't currently have a room thermostat.
Stupidly on my part I thought it would be as easy as connecting the external control lead(s) to the VOLTAGE FREE RECIEVER, not even thinking about power!
My boiler instructions state any room thermostat must be of the voltage free type which I have purchased (RT500RF).
Questions I have:
Is this a 230v AC or 24v installation?
My boiler as far as I can work out has two terminals for the thermostat(if this is the external control lead) and instructions say to remove link from boiler. How do I do this and where is link on boiler?
To get power do I just run power from the fused mains spur into the receiver, if do what's the correct way?
Do I seperate the wires currently linked together on the external white control lead, as boiler instructions state "the boiler will work for heating AS DELIVERED without a room thermostat fitted provided the two wires on the integral external controls lead REMAIN LINKED TOGETHER as supplied.
Receiver wiring terminals as follows
1: NO normally open [N/O]
2: COM linked live feed (230 AC only)
3: L Live feed (230v AC)
4: N Neutral
Please can anybody advise how I need to connect everything up, step by step, so that I don't make any costly mistakes?
I've looked at utube instructions, but not 100% sure.
Many Thanks in advance
Stupidly on my part I thought it would be as easy as connecting the external control lead(s) to the VOLTAGE FREE RECIEVER, not even thinking about power!
My boiler instructions state any room thermostat must be of the voltage free type which I have purchased (RT500RF).
Questions I have:
Is this a 230v AC or 24v installation?
My boiler as far as I can work out has two terminals for the thermostat(if this is the external control lead) and instructions say to remove link from boiler. How do I do this and where is link on boiler?
To get power do I just run power from the fused mains spur into the receiver, if do what's the correct way?
Do I seperate the wires currently linked together on the external white control lead, as boiler instructions state "the boiler will work for heating AS DELIVERED without a room thermostat fitted provided the two wires on the integral external controls lead REMAIN LINKED TOGETHER as supplied.
Receiver wiring terminals as follows
1: NO normally open [N/O]
2: COM linked live feed (230 AC only)
3: L Live feed (230v AC)
4: N Neutral
Please can anybody advise how I need to connect everything up, step by step, so that I don't make any costly mistakes?
I've looked at utube instructions, but not 100% sure.
Many Thanks in advance