Intergas combi no heating. (1)

[CountryFan]

Sorry yes mate.

Then your heating is on. Post a photo of the valve underneath

 

[Brian 1954]

Not sure what you mean or need .

 

[terryplumb]

Do you have a timer/ programmer/ thermostat ,that are all calling for heat ?
If so and boiler will not fire up you need an engineer.

 

[CountryFan]

Not sure what you mean or need .

Post a photo of the pipework underneath the boiler please including anything with a coloured tap on it.

 

[Brian 1954]

Yes all calling for heat.

 

[terryplumb]

Is the boiler doing anything at all or just sitting idle ?

 

[Jurassicspark]

Duplicate thread.

 

[Brian 1954]

Just sitting idle until I turn hot water tap on then it fires up.the only thing that the wife has said is the hot water seems hotter than normal.

 

[terryplumb]

You are going to need an engineer to visit. There are several reasons the boiler isn't firing up ,external controls or within the boiler failure.

 

[Jurassicspark]

Did you top up again/ check the boiler pressure AFTER bleeding the radiator?

Feel the pipes leaving the boiler do they feel hot?

Have you got a bypass installed in the system?

I know nothing about your boiler, find a way to reset it and try seeing if it works. If it doesn't then you might need an engineer to look at the boiler.

 

[dilalio]

You could just try the old turn power off for 30 seconds and then back on again!

Hard boot of the PCB "might" sort it!

 

[dilalio]

water outing Stafford

Water "outage"?

As in no mains water?

 

[dilalio]

Post a photo of your programmer.

Can you try it on "constant", "boost" or "override"?

 

[Brian 1954]

Hi, yeah check pressure after bleeding towel rail and top of boiler it's at 1.5 bar according to the remote thermostat the heating should be on its got wifi and there's a flame on the display to depict the heating has been requested. Don't know it's got a bypass installed and pipes are cold unless I turn a hot water tap on then 1 pipe gets hot.

 

[Deleted member 317777]

Hi, yeah check pressure after bleeding towel rail and top of boiler it's at 1.5 bar according to the remote thermostat the heating should be on its got wifi and there's a flame on the display to depict the heating has been requested. Don't know it's got a bypass installed and pipes are cold unless I turn a hot water tap on then 1 pipe gets hot.

Post a pic of the front of your boiler just to confim please