Intergas combi no heating. (1)

[terryplumb]

Brian ,is your heating now working or not ??

 

[dilalio]

According to that image it’s opposite to what we have, so could be on?

Yep. I got it wrong and have now edited my post above. Soz mate

 

[dilalio]

I'd still go for the reboot.
Same as for PCs - they're mostly computers now!

 

[Brian 1954]

Brian ,is your heating now working or not ??

No mate still no heating, I haven't touched anything. All was good until our water supply was cut then got up this morning to a rather cold house yo find that the central heating is not working but we have DHW.

 

[Brian 1954]

No mate still no heating, I haven't touched anything. All was good until our water supply was cut then got up this morning to a rather cold house yo find that the central heating is not working but we have DHW.

I'll have to get a heating engineer out tomorrow because I'm not and although I haven't touched anything apart from slightly increase the water pressure which I know how to do it's not been touched .

 

[CountryFan]

I attended one recently for the same thing, but think it was just the pressure was low. Turn the boiler off please Brian and tell us the pressure reading.

 

[Brian 1954]

I attended one recently for the same thing, but think it was just the pressure was low. Turn the boiler off please Brian and tell us the pressure reading.

I've slightly increased the pressure to 1.8 from 1.5 which it usually is at.

 

[dilalio]

Just power it off and back on again!

 

[dilalio]

I've slightly increased the pressure to 1.8 from 1.5 which it usually is at.

Intergas will happily run at @0.6bar

 

[Brian 1954]

Just power it off and back on again!

Did that before as someone suggested didn't make any difference.

 

[dilalio]

Did that before as someone suggested didn't make any difference.

So, to be clear, you turned it off completely (at the plug or fused spur) for 30 seconds?

If so, then, yes, you'll need an engineer "who is familiar with intergas boilers" if possible!

Am sure you can look this up.

 

[CountryFan]

I would try that return valve as a possibility.

 

[dilalio]

Intergas are not far from you.
Give them a call for an engineer...

 

[dilalio]

I would try that return valve as a possibility.

Can't hurt but unlikely, in unless it was operated in error when topping the boiler up from 1.5 to 1.8!

But OP says not touched and it does appear to be open!

 

[CountryFan]

Can't hurt but unlikely, in unless it was operated in error when topping the boiler up from 1.5 to 1.8!

But OP says not touched and it does appear to be open!

Yes, I’ve been searching the web and seems different photos show different positions for on and off! Bloody intergas!