Hi all,
I'm new to this and don't know the correct terms for things but hope this makes sense and that someone could offer advice!
We've just had our bathroom renovated and have had a thermostatic/rigid riser type shower installed where there was no shower previously.
When we turn the shower on, the pressure is normal for about a minute, and then after that the flow becomes intermittent, like morse code almost. I went to look at the boiler when it was doing this, and the pressure seemed to be set at around 2, but flicking slightly and making a clicking noise - like a clock hand when the batteries are running out.
The shower only needs pressure of 0.5 to function, according to the user manual, so not sure what is going on? Can anyone shed any light on this please?
Thanks,
Emma
I'm new to this and don't know the correct terms for things but hope this makes sense and that someone could offer advice!
We've just had our bathroom renovated and have had a thermostatic/rigid riser type shower installed where there was no shower previously.
When we turn the shower on, the pressure is normal for about a minute, and then after that the flow becomes intermittent, like morse code almost. I went to look at the boiler when it was doing this, and the pressure seemed to be set at around 2, but flicking slightly and making a clicking noise - like a clock hand when the batteries are running out.
The shower only needs pressure of 0.5 to function, according to the user manual, so not sure what is going on? Can anyone shed any light on this please?
Thanks,
Emma
