Hi
I am due to replace my kitchen sink. To do this I will need to increase the existing cutout by approximately 15mm. I am working with a laminated worktop
So my problem is
The current cutout is the exact same width of the cabinet below. If I try and use a jigsaw I presume the blade will either bounce of the top of the side wall of the carcass or bend the blade.
I am after some tips of how I can achieve a neat finish. Shall I cut the side wall of the carcass? There are floor carcasses either side of sink unit
Tia
I am due to replace my kitchen sink. To do this I will need to increase the existing cutout by approximately 15mm. I am working with a laminated worktop
So my problem is
The current cutout is the exact same width of the cabinet below. If I try and use a jigsaw I presume the blade will either bounce of the top of the side wall of the carcass or bend the blade.
I am after some tips of how I can achieve a neat finish. Shall I cut the side wall of the carcass? There are floor carcasses either side of sink unit
Tia