I have a BS5433 crutch head stoptap ( manufacturer Samuel Booth ) which is connected to 32mm mdpe at one end and 28mm copper at the other. It is leaking from the bonnet seals but as it is in a difficult location to remove and replace I would prefer to unscrew the bonnet and replace the seals. Note: I can isolate the incomming supply from another stoptap down the line to do this. Can I obtain a replacement seal kit or bonnet assembly from anywhere?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Leaking Stoptap
- Thread starter noswada
- Start date
Try a wee bit ptfe tape 3 or 4 turns or & liquid locktight ptfe ,most likely fibre washer has gone,you only need to reseal without looking at it. hope this helps .
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
