Loose kitchen plinth
- Thread starter JM72
- Start date
- Joined
- 6 May 2025
- Messages
- 212
- Reaction score
- 74
- Country
Those are angle plates, not clips, so you'd need to screw through from behind..
Probably easier to put a blob of silicone on each then press the piece of plinth in place.
Probably easier to put a blob of silicone on each then press the piece of plinth in place.
Looks like it’s just wedged in place with brackets to stop it in correct position .
Countersink a couple of magnets, into the back of the plinth, and it will snap into place.
A swift way of securing those shrinker plate is with a hot glue gun and within seconds a fix without raising a sweat 
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
