I'm getting 10l/m on our Mira Combiflow shower done via the bucket test both with and without the shower head attached. We get 12l/m on all other taps hot and cold through the house.
Mira came out and replaced the cartridge under warranty and cleaned the filters out. Any flow reducers or savers have been removed so I am not sure why the flow is still down, this makes the shower just that little bit less pleasant. All cut off valves etc are fully open. The only thing left is the filters but they are clean and the shower cannot be fitted without them. I www thinking of drilling a hole through the filter to allow water to pass through?
Any ideas? This is the manual http://www.mirashowers.co.uk/onlinecatalog/pdf/p4479_2.pdf
Regards
Mira came out and replaced the cartridge under warranty and cleaned the filters out. Any flow reducers or savers have been removed so I am not sure why the flow is still down, this makes the shower just that little bit less pleasant. All cut off valves etc are fully open. The only thing left is the filters but they are clean and the shower cannot be fitted without them. I www thinking of drilling a hole through the filter to allow water to pass through?
Any ideas? This is the manual http://www.mirashowers.co.uk/onlinecatalog/pdf/p4479_2.pdf
Regards