Main water shutoff valve problem and water company

Joined
12 Jul 2011
Messages
470
Reaction score
17
Location
Stirlingshire
Country
United Kingdom
Even when the main water shutoff valve is totally off for shutting off the water, water still trickles out into the cut pipes without fully stopping.
Could this be due to the rubber washer perished or shrank in the wheel shaped old valve through time? Could this be requested to the water company for replacement? Or the house residents must be replacing them by themselves?
 
The one in the house is the homeowner's responsibility, could be just a washer.
 
You describe it as a wheel shaped valve. If by this you mean it has a circular handle (often coloured red), then it may well be a gate valve. These do not have rubber washers but rely on a wedge shaped brass part to shut off the flow. Except when brand new they rarely seal completely.
 
Did you drain everything via the lowest point?

Yes, after shutting off the valve I put on the downstairs taps for about 10 minutes trying to drain all the water in the pipes before going up to the loft and taking out the lever handled shut-off ball valve. Water from the mains pipe in the loft kept trickling out once the pipe was open. Had to stop it using the Nerad 22mm water stopper (which came really useful).

But was wondering, why is this the case when the mains shut off valve had been totally closed.
 
Last edited:
You describe it as a wheel shaped valve. If by this you mean it has a circular handle (often coloured red), then it may well be a gate valve. These do not have rubber washers but rely on a wedge shaped brass part to shut off the flow. Except when brand new they rarely seal completely.

Maybe that could have been the reason. Would best option be replacing it with a lever handled shut-off ball valve?
 
The one in the house is the homeowner's responsibility, could be just a washer.

It is located in the real awkward point at the corner near the kitchen sink blocked and covered by the worktop. Very difficult to even to reach to access for opening and shutting. Also I cannot confirm the diameter of the pipe it is connected to. Could it have to be professional plumber's job?
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top