Marmox Showerlay Drain Solvent weld connect to push fit?

[fabgav]

Hi all, i'm having a nightmare with this.

I;ve got this http://www.tilefixdirect.com/product/MXDRAIN.html and need to know how to connect it to the rest of my waste system.

As it stands I wanted to connect this to my bath waste which is 40mm pushfit however I understand this is not possible?

I can run this straight outside but want to connectec to the bath outside to go into one waste pipe run down the drains just so it looks neat.

Any ideas?

I dont really want to have to go out and buy all kit needed for solvent weld stuff.

The outside is 50mm so a uni pipe thing like http://www.screwfix.com/prods/81383...n-Waste/Flexi-Waste-Straight-Coupling-38-45mm wont fit either?

Plus its a rip off for a bit of rubber pipe and two metal rings!

 

[kevplumb]

I dont really want to have to go out and buy all kit needed for solvent weld stuff.

what "kit" strip of abrasive and a can of solvent cement

jeez if your gonna do the job

do it right

 

[seco services]

I wanted to connect this to my bath waste which is 40mm pushfit

you sure its pushfit not compression waste pipe ?

 

[fabgav]

Sorry bath waste trap Is compression which I have connected and then the rest of run is push fit.
I just dodnt want to buy a whole tub of solvent to use on one joint but if thats the only way I have to buy solvent waste pipe too?

 

[muggles]

Solvent weld waste is better - no chance of it pulling apart or losing it's seal. You can get half-size tubs of solvent weld if you don't want a big one. SW waste pipe should fit in your trap's compression joint

 

[DavidDaft]

should run it seperate to the bath anyway