Hi,
Whilst looking into why my washing machine would occasionally cut out mid-cycle (but work again if restarted half an hour later) I noticed that one of the pins on the plug has built up a collar of melted metal, which is forcing the plug back out of the socket (presumably as it heats up, which is why leaving it a while helps).
I'm guessing this isn't good - and it shouldn't be used at all until sorted.
As far as I can see the plug will need replacing - and the socket. Are there any other likely implications?
The plug is moulded one-piece and the socket is a double.
In the short-term, simply cutting off the plug, fitting a new one (with the same fuse rating, presumably 13amp for a washer/dryer) and plugging this into the other socket seems like a plan. When I get a little more time I could replace the double socket (to avoid someone else in the future using it).
Can anyone see any likely problems or complications with this (I've read that the plug needs to be disposed of carefully, since its a child's accident waiting to happen)? I don't think replacing sockets (even in the kitchen) or a moulded plug requires any part p certification, but my level of knowledge is low - about enough to wire a plug and replace a (non-bathroom) light fitting at the moment.
Thanks in advance for any advice.
Whilst looking into why my washing machine would occasionally cut out mid-cycle (but work again if restarted half an hour later) I noticed that one of the pins on the plug has built up a collar of melted metal, which is forcing the plug back out of the socket (presumably as it heats up, which is why leaving it a while helps).
I'm guessing this isn't good - and it shouldn't be used at all until sorted.
As far as I can see the plug will need replacing - and the socket. Are there any other likely implications?
The plug is moulded one-piece and the socket is a double.
In the short-term, simply cutting off the plug, fitting a new one (with the same fuse rating, presumably 13amp for a washer/dryer) and plugging this into the other socket seems like a plan. When I get a little more time I could replace the double socket (to avoid someone else in the future using it).
Can anyone see any likely problems or complications with this (I've read that the plug needs to be disposed of carefully, since its a child's accident waiting to happen)? I don't think replacing sockets (even in the kitchen) or a moulded plug requires any part p certification, but my level of knowledge is low - about enough to wire a plug and replace a (non-bathroom) light fitting at the moment.
Thanks in advance for any advice.