mixer basin tap with only 1 feed?

[Rico99]

mysteryman,

Just been reading up on that, surley that only comes into play on newbuilds on upon creation of a new room or change of use.

If its an existing bathroom / cloakroom, then the regs would not apply.

Rico

 

[Whitespirit66]

okaaayy...

so if nobody has seen them before..plus the tap connectors would be on flexi rather than copper...

maybe its a silly job?

Can you get single cold taps that are all pretty and fancy for her?

or any other ideas?

Get 'Er Indoors her posh monobloc tap.

Attach a 15mm equal compression tee (if you don't want to solder) to the cold water pipe. Next, put a 3 inch length of 15mm copper pipe in each of the two tees of the compression tee fitting that are unused. Lastly, connect each of the 2 flexi tap tails to the other end of the 3 inch copper pipes.

Simples!