mixer basin tap with only 1 feed?


Just been reading up on that, surley that only comes into play on newbuilds on upon creation of a new room or change of use.

If its an existing bathroom / cloakroom, then the regs would not apply.

Sponsored Links

so if nobody has seen them before..plus the tap connectors would be on flexi rather than copper...

maybe its a silly job?

Can you get single cold taps that are all pretty and fancy for her? :rolleyes:

or any other ideas?

Get 'Er Indoors her posh monobloc tap.

Attach a 15mm equal compression tee (if you don't want to solder) to the cold water pipe. Next, put a 3 inch length of 15mm copper pipe in each of the two tees of the compression tee fitting that are unused. Lastly, connect each of the 2 flexi tap tails to the other end of the 3 inch copper pipes.

Simples! ;)

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Sponsored Links