I had a new ecotec plus 831 boiler fitted last week.
Heating and hot water are working fine, but I noticed the pressure gauge needle was a bit into the red last night. It's been off all day and now it's back on the needle is in the red again.
Display is flashing between 60 degrees C and 3.0 bar pressure.
Should I be worried?
Heating and hot water are working fine, but I noticed the pressure gauge needle was a bit into the red last night. It's been off all day and now it's back on the needle is in the red again.
Display is flashing between 60 degrees C and 3.0 bar pressure.
Should I be worried?