Hi all,
Just had a call from the in-laws, they have no hot water flow to their bathroom basin mixer tap this morning.
The flow to that particular tap has always been pretty rubbish. The system is a conventional open vent storage cylinder.
Having a look around on here, the problems seem to centre around,
1. Air lock (doubt it's this as there has been some flow and no recent mods to the system)
2. Sludge/cr@p in the system somewhere, be it scale in the pipework or blocked filters on the tap (most likely I think as it seems to have been gettin gprogressively worse).
I know it's a big ask, not having seen the set up etc, but does anyone have any other suggestions as to what it may be (before I head over there later today and get wet?)
All replies greatly appreciated!
Just had a call from the in-laws, they have no hot water flow to their bathroom basin mixer tap this morning.
The flow to that particular tap has always been pretty rubbish. The system is a conventional open vent storage cylinder.
Having a look around on here, the problems seem to centre around,
1. Air lock (doubt it's this as there has been some flow and no recent mods to the system)
2. Sludge/cr@p in the system somewhere, be it scale in the pipework or blocked filters on the tap (most likely I think as it seems to have been gettin gprogressively worse).
I know it's a big ask, not having seen the set up etc, but does anyone have any other suggestions as to what it may be (before I head over there later today and get wet?)
All replies greatly appreciated!
