No room for soakers and flashing pics - HELP

[des606]

Bad planning has meant that the space between my new shed roof and the pantiles on the adjoining shed narrows to near nothing at the bottom / eaves, leaving no room to install the bottom soakers / and embed flashing into wall.

[/img]http://i230.photobucket.com/albums/ee190/leixlipswift/Image097.jpg




While felt/battening and tiles will fit underneath the pantiles on the roof in picture below - looking ahead to soakers / flashing how will I fit/ adjust them as the wall space for mortaring flashing narrows to nothing.

wall at narrowest point is also badly cracked, so even if I could get a grinder in , it would likely crumble.

Is there a way of doing this last section by using some kind of adhesive flashing(i know not recommended) or some felt attached with adhesive??

Any ideas what could be done at this point where the tiles will meet?

Thanks

 

[Alastairreid]

no pic des................anyway a piece of sheet lead under the pantiles going down onto your new roof (without a pic this is what i surmise)