Hi, I fitted a replacement Wickes sanipump, the newer model was slightly bigger and less wattage I think, it has the WC, small basin and bath that go into it. I had to slightly raise it off the floor one side(about 1inch) because of fitting it in with the existing pipework. It works perfectly fine but after you use one of the appliances attached to it, the macerator chops it up and gets rid of the waste but then there is a delay and a (electrial)buzzing noise continues for quite some time. I am going to ring Sanipump on Mon but wondered if any smart people out there might have any thoughts on it? Thankyou
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Noisey NEW Sanipump HELP!???
- Thread starter Rachh863
- Start date
just follow these three simple tips
1 disconnect power supply
2 empty as much as you can by taking off top cover and disconnect pipework
3 throw saniflow in nearest skip
hope this helps and don't ever think about fitting another one.
1 disconnect power supply
2 empty as much as you can by taking off top cover and disconnect pipework
3 throw saniflow in nearest skip
hope this helps and don't ever think about fitting another one.
I completely agree!!!
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
