I’m getting intermittent vibration and noise from a newly installed Danfloss auto by-pass valve. This was put in following installation of Dayton TRVs on all my rads. I can isolate the valve and the noise stops but would like to know if removing a TRV head from, say, a bathroom towel rail ( or just setting it to max) would provide a safe temporary alternative whilst I await the return of my plumber to check out the bypass valve? I can’t get hold of my plumber to ask him.
Noisy Auto by-pass valve
- Thread starter wbjimmy1
- Start date
Sponsored Links
yes it is fine as a temp measure to just remove a TRV head, your by-pass valve will have a direction arrow on it, make sure it is fitted in the correct direction
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
