1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice

Plunge Pool Rendering

Discussion in 'Plastering and Rendering' started by spax2450, 15 Jun 2021.

  1. spax2450

    spax2450

    Joined:
    15 Jun 2021
    Messages:
    1
    Thanks Received:
    0
    Country:
    United Kingdom
    Hi, I’m new to the forum and could really do with some advice!

    I’ve just built a small (6x6x4ft) plunge / exercise pool.

    It’s built from breeze block, very solid, I’m pretty clueless about rendering it though.

    I’ve used SBR, sand and cement to fillet (?) all the edges, next job is to render it ready to paint on the 2 part swimming pool epoxy paint.

    I know I need to paint PVA on’t walls before rendering. Should I add SBR to the render mix? ‍♀️ What ratio? And will it be ok with 2 part epoxy swimming pool paint going over it?

    I’ve asked the company where I bought the paint from, and another supplier but they said to ask a builder.

    Thanks so much for any advice!
     
  2. Sponsored Links
  3. Alastairreid

    Alastairreid

    Joined:
    21 Nov 2008
    Messages:
    6,661
    Thanks Received:
    1,084
    Location:
    uk
    Country:
    United Kingdom
    I know nothing about swimming pool construction but I do know you would not use pva as it is water soluble.
     
Loading...

Share This Page